六六字典>英语词典>chamfer翻译和用法

chamfer

英 [ˈtʃæmfə(r)]

美 [ˈtʃæmfər]

n.  斜切面; 削角

复数:chamfers 现在分词:chamfering 过去分词:chamfered 过去式:chamfered 第三人称单数:chamfers 

COCA.44768

牛津词典

    noun

    • 斜切面;削角
      a cut made along an edge or on a corner so that it slopes rather than being at 90˚

      英英释义

      noun

      • two surfaces meeting at an angle different from 90 degrees
          Synonym:bevelcant

        verb

        • cut a furrow into a columns
            Synonym:furrowchase
          1. cut a bevel on
            1. bevel the surface
            Synonym:bevel

          双语例句

          • Carefully remove smaller edges or burrs on the chamfer of the crankshaft flange with an oilstone if necessary.
            如有必要,请用油石仔细去除曲轴法兰倒棱上的小边或毛刺。
          • This paper analyzes the lack of traditional settingout method and the advantage of digitalization settingout method when analyzing settingout of chamfer stake in cubic meter of earth and stone.
            分析了土石方工程中坡口桩放样时,传统放样方法的不足和数字化放样方法的优点。
          • Fit the sealing ring at the correct position in the vacuum pump so that it is flush with the lower edge of the chamfer in the rotor.
            将密封圈安装在真空泵的正确位置,以便密封圈与转子倒棱的下边缘平齐。
          • But for Reminder: the dimensions related to big chamfer are not major characteristic.
            但提醒:大倒角的尺寸并不大特点。
          • RECHAMFER: Defect on radii and chamfer; defective chamfer such as nicks that are considered to be repairable.
            重新倒角:可被重新修复的倒角缺陷,例如划痕。
          • What is the nominal chamfer size?
            什么是公称倒角尺寸?
          • The specialized inspector inspects the bore diameter, pitch, chamfer and finish degree of bore wall.
            加工完成后由专门检验员检验孔径、孔距、倒角大小、孔壁光洁度。
          • Drag to add perpendicular lines with adjustable chamfer size.
            拖动此形状,可添加切角可调的垂直线。
          • In addition, this paper compares this technology with gear chamfer technology of grinding wheels and finds the advantages of flexibility abrasive deburring technology.
            并与砂轮齿轮倒角技术进行了对比,总结出了柔性研磨回转体去毛刺技术的优点。
          • Core drills. A core drill consists of the chamfer, body, neck, and shank, as shown in Fig.12.2.
            空心钻包括斜面、钻头体、钻颈和钻柄,如图12.2所示。